Wika CPC6000 Uživatelský manuál stáhnout pdf (Strana 24)

Automated Pressure Calibrator

CPC 6000

24 Mensor/WIKA Operating Instructions - CPC 6000

4.4 General Specifications

Size 14.02” wide x 7.55” high x 12.42” deep (35.61 cm x

19.2 cm x 31.55 cm). See Figure 5.2.

Weight 36 lbs. (16.33 kg) with all internal options.

Power Input Requirements 100-240 VAC, 47-63 Hz, 75 VA max.

Fuses: 1.5A, 230V, Type T LITTLEFUSE 31301.5

Digital I/O Pin 1: +5 VDC, 100 mA max.

Pin 2: Input TTL levels. Voltage input should be limited

to > -0.3 VDC and < +5.3 VDC.

Pin 3: Output pulled up to 5 VDC with a 10k ohm

resistor. Source limited to 450uA, Sink 10mA

Pin 4: Ground.

Pneumatic Interfaces 7/16” – 20 female SAE.

1/8” FNPT adapters provided.

Particle Filters The instrument has 20-micron filters on all pressure

ports through the manifold.

The barometric transducer has no filters.

Pneumatic Overpressure Protection Sensors are protected by relief valves.

Compensated Temperature Range 15°C to 45°C.

Operating Temperature Range 0°C to 50°C. Note: This is not the compensated

temperature range.

Storage Temperature Range 0°C to 70°C. Minimal vibration.

Non-condensing humidity.

Local User Interfaces 8.4” color LCD display with 8 wire resistive touch

screen.

Remote User Interfaces RS-232, Ethernet, and IEEE-488.1 are standard.

Warm-up Approximately 15 minutes to achieve full accuracy

depending on environment.

Reading Rate Typically 32 readings per second.

Measure Response Time <333 mS for FS step.

Orientation Effects Negligible, can be removed with re-zeroing.

Operating Environment 5 to 95% RH non-condensing.

Pressure Media Clean, dry, non-corrosive, non-combustible, non-

oxidizing gases. Not suitable for oxygen use.

Compliance

See section “1.3 Compliance”

Options Transport Case, Rack Mount Kit, Calibration Sled

Kit, Secondary Transducer, Barometric Reference

Transducer, Virtual Delta Channel

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 103 104

Žádné komentáře

Wika CPC6000 Uživatelský manuál Strana 24