Wika IPT-11 Uživatelský manuál stáhnout pdf (Strana 26)

To select the adjustment unit (in the example switching over from bar

to mbar) you have to proceed as follows:

1 Push the [OK] button in the measured value display, the menu

overview is displayed.

▶

Basic adjustment

Display

Diagnostics

Service

Info

2 Conﬁrm the menu "Basic adjustment" with [OK], the menu item

"Unit" will be displayed.

Unit

Unit of measurement

bar

▼

Temperature unit

°C

▼

3 Activate the selection with [OK] and select "Units of measure-

ment with [->].

4 Activate the sel ection with [OK] and select the requested unit with

[->] (in the example mbar).

5 Conﬁrm with [OK] and move to position correction with [->].

The adjustment unit is hence switched over from bar to mbar.

Information:

When switching over to adjustment in a height unit (in the example

from bar to m), the density also has to be entered.

Proceed as follows:

1 Push the [OK] button in the measured value display, the menu

overview is displayed.

2 Conﬁrm the menu "Basic adjustment" with [OK], the menu item

"Units of measurement" will be displayed.

3 Activate the sel ection with [OK] and select the requested unit with

[->] (in the example m).

4 Conﬁrm with [OK], the submenu "Density unit" appears.

Unit of measurement

Density unit

▶

kg/dm³

pcf

5 Select the requested unit, e.g. kg/dm³ with [->] and conﬁrm with

[OK], the submenu " D ensity" appears.

Selection options: mbar, bar, psi, Pa, kPa, MPa, inHg, mmHg, inH

mmH

26 Process pressure transmitter IPT-1* Vers. 3.0 - metalic sensor • 4 … 20 mA/HART

6 Set up with the indicating and adjustment module

31543-EN-090130

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 55 56

Komentáře k této Příručce

Žádné komentáře

Wika IPT-11 Uživatelský manuál Strana 26

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Wika IPT-11