Wika IPT-11 Uživatelský manuál Strana 14

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 36
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 13
l Min. and max. temperature
2)
Pointer
In this menu item, the device status is displayed. If the sensor detects
a fault, "OK" will be displayed. If a fault is detected, a ashing failure
message is outputted sensor-specically, e.g. "E013". The fault is also
displayed in clear text, e.g. "N o measurement value".
Information:
The fault message as well a s the clear text indication are also carried
out in the measured value display.
Meas. reliability
Sensor status
Available with the trend curve:
l "X-Zoom": Resolution in minutes, hours or days
l "Stop/Start": Interrupt a recording or start a new recording
l "Unzoom": Reset the resolution to minutes
Trend curve
Menu section, service
In this menu item you simulate a user-dened level or pressure value
via the current output. This allows you to test the signal path, e .g.
through connected indicating instruments or the input card of the
control system.
The following simulation variables are available:
l Percent
l Current
l Pressure
With Probus PA sensors, the selection of the simulated value is made
via the "Channel" in the menu " Basic adjustments".
How to start the simulation:
2)
Temperature: -50 +150 °C.
Sensor status
Curve presentation
Simulation of
measured val-
ues
14 Indicating and adjustment module for IPT-1* sensors
5 Set up
31549-EN-081211
Zobrazit stránku 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Komentáře k této Příručce

Žádné komentáře