Wika WUC-16 Uživatelský manuál stáhnout pdf (Strana 7)

11384850.07 GB/D 06/2014

WIKA Operating instructions / Betriebsanleitung WUC-1x

5. For your safety / 6. Packaging GB

WARNING!

■

Remove the pressure transmitter from service and mark it to prevent it from being used again accidentally, if it

becomes damaged or unsafe for operation

■

Take precautions with regard to remaining media in removed pressure transmitter. Remaining media in the

pressure port may be hazardous or toxic!

■

Have repairs performed by the manufacturer only.

■

The operator is responsible for the material compatibility as well as correct handling, operation and mainte-

nance.

Information about material consistency against corrosion and diusion can be found in our WIKA-Handbook, 'Pressure and

Temperature Measurement'.

WARNING!

For transducer with Ex-/FM-marking: Consider the relevant safety instructions as well as the respective country

specic regulations for installation and operation in hazardous areas (e.g.: IEC 60079-14, NEC). If you do not

observe these stipulations, serious injuries and/or damage may occur.

6. Packaging

Has everything been supplied?

Check the scope of supply:

■

Completely assembled transducer

■

Inspect the transducer for possible damage during transportation. Should there be any obvious damage, inform the trans-

port company and WIKA without delay.

■

The UHP transducers are puried, evacuated and double-packed in clean rooms in a protective atmosphere (clean room

class 5 according to ISO 14644). Special plastic protective caps are used to protect the high-quality threaded connections

(ttings). The gauges should remain in this special packaging until installation in order to prevent damage and contamina-

tion. Therefore remove the ESD (Electro-Static-Discharge) protective foil only at the place of installation.

■

Keep the packaging, as it oers optimal protection during transportation (e.g. changing installation location, shipment for

repair).

■

Ensure that the pressure connection thread and the connection contacts will not be damaged.

■

Remove this protection cap only just before installing the transducer.

■

Mount the protection cap when removing and transporting the instrument.

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Komentáře k této Příručce

Žádné komentáře

Wika WUC-16 Uživatelský manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Wika WUC-16