Wika WUD-26 Uživatelský manuál stáhnout pdf (Strana 16)

Operating instructions/Betriebsanleitung, WUD-2x

11611057.01 GB/D 11/2013

1. LED (red) - Status Switch Output 1

2. LED (red) - Status Switch Output 2

3. LED (red) - Ready LED

Parameter

Parameter Description

SP1 / SP2 Hysteresis function: Switch point, switch output (1 or 2)

RP1 / RP2 Hysteresis function: Reset point, switch output (1 or 2)

EF Enhanced Programming Functions

RES Return the set parameter to the Factory Settings

DS1 Switch Delay Time, which must occur without interruption before any electrical signal change occurs (SP1 or SP2)

DS2

DR1 Switch Delay Time, which must occur without interruption before any electrical signal change occurs (RP1 or RP2)

DR2

OU1 Switching Function Switching Output (1 or 2)

OU2 OFF = always o

ON = always on

NO = normally open

NC = normally closed

DISU Display-Update 0.2, 0.5, 1, 5, 10, 60 seconds

DISO Display zero point oset (± 10 % of full scale)

(This setting has no eect on the ouput signal. Only the displayed value will be set.)

Error Display

Error Description

ATT Setting out of range (Acknowledgement of an error display by pressing the main key)

OL Overpressure, measuring range exceeded > approx. 5% (Display ashing)

UL Underpressure, under measuring range < approx. 2% (Display ashing)

7. Initial start-up and operation

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Žádné komentáře

Wika WUD-26 Uživatelský manuál Strana 16