Wika UPT-21 Uživatelský manuál stáhnout pdf (Strana 20)

WIKA operating instructions process transmitter, model UPT-2x

14068347.01 06/2014 GB/D

5. Transport, packaging and storage

5.1 Transport

Check the process transmitter for any damage that may have been caused by transport.

Obvious damage must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting.

Keep the packaging as it will provide optimum protection during transport (e.g. change

in installation site, return for calibration).

5.3 Storage

Permissible conditions at the place of storage:

■

Storage temperature: -40 ... +80 °C

■

Humidity: 35 ... 93 % relative humidity (no condensation)

Avoidexposuretothefollowingfactors:

■

Proximity to hot objects, when permissible storage temperature is exceeded by

radiation

■

Mechanical vibration, mechanical shock (putting it down hard), when the permissible

values are exceeded, see chapter 3 “specications”

■

Soot, vapour, dust and corrosive gases

■

Hazardous areas and ammable atmospheres where the instruments are not suitable

for installation in or mounting to equipment in explosive atmospheres.

Store the process transmitter in its original packaging in a location that fulls the condi-

tions listed above. If the original packaging is not available, then store the instrument

in a container that is similar to the original packaging, so that the instrument can't be

scratched and is protected against damage if dropped.

WARNING!

Before storing the instrument (following operation), remove any residual

media. This is of particular importance if the medium is hazardous to health,

e.g. caustic, toxic, carcinogenic, radioactive, etc.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 119 120

Žádné komentáře

Wika UPT-21 Uživatelský manuál Strana 20